NEW USED PARTS ORDERING PAYMENT SHIPPING WARRANTY RETURNS
TECH RESOURCES GALLERY WANTED LINKS NEWS EBAY FAKES
HOME NAMM FEEDBACK TESTIMONIALS CONTACT EMAIL
NEW GUITARS USED GUITARS PARTS
To replace the studs first pull the trem as shown above. So you don't mix them up replace one at a time. Unscrew the stud from it's anchor. Hold it next to the replacement stud and align the point of the V grooves up as close as possible. Using the wrench for the set screws wind the set screw of the replacement stud down to match the stud you are replacing. This will keep the action very close to what you had previously. Screw the new stud in and repeat for the other. Reinstall the trem.
Because no two batches of studs are cut exactly the same you will have to do some setup tweaks. Some of the V's will be cut deeper, some not as deep. First, retune of course. Check and correct the trem angle, then tweak the action height if you notice any difference. You might also need to reset the intonation.